Kyocera KM-C830D - Page 12

7
2. Set-up
Press the
PP
PP
P cursor key and then enter the next 3 digits of
the IP address into the next highlighted block.
Continue the same procedure for the other 2 blocks and,
once the IP address has been entered, press the Enter key.
Use the M and N cursor keys to select “Subnet Mask” and
then press the Enter key.
Repeat steps 11 - 13 in order to enter the Subnet Mask
using the same procedure that you did for entering the IP
address.
Use the M and N cursor keys to select “Gateway” and then
press the Enter key.
Repeat steps 11 - 13 in order to enter the Gateway address
using the same procedure that you did for entering the IP
address.
Once you are finished making all of the network settings,
press the Copier key. The machine will switch back to the
copier mode.
12
13
14
15
17
16
18
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification