4-1
4Copying
Basic Operation
Follow the steps as below for basic copying.
1 Configure necessary settings in KYOCERA Client Tool in advance. Refer to Machine Settings on page 3-36.
2 Press the Function Select key to turn on the Copy Indicators.
3 Place the originals. For details, refer to Loading Originals on page 3-12.
4 To use a program, select the program number (P0 to P3).
Press the Mode Select key to turn on the Program Indicators, and press [+] or [-] to select the program number.
5 Enter the number of copies.
Press the Mode Select key to turn off the Function Indicators, and press [+] or [-] to enter the number of copies.
6 Adjust density using 7 levels (-3 (Lighter) to 3 (Darker)).
Press the Mode Select key to turn on the Density Indicators, and press [+] or [-] to select your desired density.
7 Press [Start] ( ) to start copying.
Note For details on functions that are registered in programs, refer to Using Programs on page 4-4.
P0 is the status with no program set.
To Next Page
Loading...
Need help?
General