How do I check the Toner Level on
my PA2000w?
Remaining Toner can be found on the printer Status Page. You can print reports to check the
machine status, and event log.
Remaining Toner can also be located on the Client tool under supplies.
When [Main power] is pressed. Attention indicator
and Main Power Indicator flash at the same time, and
the machine switches to the Report Print Mode. A
report can be printed by pressing and holding [Main
power] in this state.
A report to be printed can be selected with the
pressing length.
+ Pressing for 5 seconds: Prints the status page.
+ Pressing for 10 seconds: Prints the network status
page (MA2000 / MA2000w).
+ Pressing for 15 seconds: Prints the event log page.
Note: While pressing [Main Power]. Attention
indicator and Main Power indicator blink twice
alternately in 5 seconds intervals.
To Next Page
Loading...
