Kyocera TASKalfa 1800 - Confirming the Registered Program

5-26
Operation on the Machine > Copying
4 Enter a program name using the numeric keys and press the [OK] key.
The program is registered.
Confirming the Registered Program
The settings of the registered program can be confirmed by recalling the program. Refer to Recalling Program on page
5-26.
Recalling Program
Use the procedure below to recall a registered program.
1
Recall the program.
1 Press the [Program] key.
2 Press the [▲] or [▼] key to select a program number (01 to 04) to recall, and press the
[OK] key.
3 Press the [▲] or [▼] key to select [Recall], and press the [OK] key.
2
Execute the program.
Place the originals and press the [Start] key.
Character Entry Method (page 10-4)
NOTE
• Up to 32 characters can be entered.
• If the program number is already used in any of the existing programs, the change
confirmation screen appears. Press the [▲] or [▼] key to select [Yes] or [No], and
press the [OK] key.
• The settings can be confirmed by recalling the program. Refer to Recalling Program
on
page 5-26.
Program Name
2
1
Select program
Program 01
21
Program 01
Recall
21