5-33
Operation on the Machine > Scanning
Use Your Desired Destination
If there are settings that you change from "My Documents" in the computer (Host PC) connected to the machine via
USB, set the destination by using KYOCERA Client Tool. You can simply select the destination number as needed to
recall those functions.
Ten destinations including the default [Local PC] can be registered. Refer to Default Settings on the PC (KYOCERA
Client Tool) on page 7-16.
1
Start KYOCERA Client Tool on the Host PC.
Refer to Accessing KYOCERA Client Tool on page 2-18.
2
Press the [Scan] key on the machine.
3
Place the originals.
4
Select the destination number.
Press the [▲] or [▼] key to select a destination number (01 to 10) to recall, and press the [OK]
key.
5
Press the [Start] key.
Scanning starts.
When the scan ends, the folder in which an image is saved opens on the Host PC.
Loading Originals (page 5-2)
The name set by using KYOCERA Client Tool appears. [----------------] appears for the
destination for which no name is set.
To Next Page
Loading...
