Device Settings
Identification
Identification lets you identify your print job with a User name and
Department name, up to 31 characters, that can appear in the Operation
panel message. The User name can be used to identify a print job stored on
the hard disk or RAM disk.
Setting User Identification
You can type User name and Department information to be used with the Job
Storage (e-MPS) feature.
1
In Device Settings > User, type your preferred name in the User name text
box.
2
Type your department or group name in Department text box.
You can type up to 31 characters in the User name and Department text
boxes.
3
Click OK in the User Settings and Properties dialog box.
Units
You can set Inches or Millimeters as the unit of measurement. This is used for
the following settings:
Custom page size setting in the Page Sizes dialog box in the Basic tab.
Spacing setting in the Watermark Add and Edit dialog boxes in the
Advanced tab.
Poster settings in the Layout tab.
Gutter settings in the Finishing tab.
Selecting a Unit of Measurement
You can select a unit for displaying measurements in the user interface.
1
In Device Settings > User Settings, select Inches or Millimeters.
2
Click OK in the User Settings and Properties dialog boxes.
Language Preference
The Language preference option specifies the user interface language of
Device Settings in Properties and all tabs of Printing Preferences.
Available languages vary depending on your locale and your computer settings.
Setting Language Preference
You can select a user interface language.
1
In Device Settings > User Settings, select the desired language from the
Select language list.
2
Click OK in the User Settings and Properties dialog boxes.
KX DRIVER
2-12
To Next Page
Loading...
