Kyocera TASKalfa 350ci - Page 4

(Page.4/11)
Service Bulletin Ref. No. 2TV-0015 (J130)
(Service information) <Date> July 19, 2019
KYOCERA Document Solutions Inc.
For authorized KYOCERA engineers only.
Do not distribute to non-authorized parties.
A
B
C
CONFIDENTIAL
Procedures to attch the dust filter and filter mounting holder
(Estimate work time: 10min. or less)
No
Procedure
Detail
1
Detach the middle left cover (a) and lower left
cover (b), and clean around the louver (c) of
inner and outer side of the machine. (Refer to
each model service manual Chapter4
[Detaching/reattaching the lower left cover] for
the procedures to detach the above cover.)
Reattach the middle left cover (a) and lower left
cover (b) after cleaning.
2
Clean around the louver (d) at the outer side of
the main unit with alcohol.
3
Affix 3 pcs. double sided tape (f) to the filter
mounting holder (e).
Note:
The double sided tape (f) should not run over
the sticking area of the filter mounting holder (e)
(Figure for 40ppm printer)
c
a
b
(Example)
c
d
e
f