A simple and inexpensive way for Cost Savings through Energy monitoringA simple and inexpensive way for Cost Savings through Energy monitoring
Max amount of data (reference)
Voltage (True RMS), Current (True RMS), active power, apparent power, reactive power, active energy, apparent energy, reactive energy,
power factor (cos
θ
), frequency, demand measurement, current flowing on the neutral line (only on 3phase 4 wire measurement)
Data saved on an SD card or internal memory of KEW6305 can be directly transferred to a computer
via USB. USB ver. 2.0 is supported.
1/2/5/10/15/20/30 second/seconds 1/2/5/10/15/20/30 minute/minutes 1hour
SD cards up to 2GB can be used.
*in case the SD card is empty
Not only the total power and power factor are shown but also the breakdown related to each phase
The last 10 measurements saved on SD card or internal memory are displayed
on the LCD.
This function allows quick checks of the recorded data without using a PC.
In case of a mains blackout, the power to the instrument is automatically supplied by the Alkaline batteries (Max
continuous measurement: 15 hours)
In the case of both power supplies to the instrument being interrupted, recorded data just before the event of the
interruption will be saved.
Rechargeable nickel-hydrogen batteries can be used
Automatic creation of graph and list from recorded data.
Uniform management of setting and recorded data acquired from multiple devices.
Data can be expressed in crude oil and CO
2
equivalent values in the report.
Tablet device
Power and Energy measurementsPower and Energy measurements
Data transmission via USBData transmission via USB
Recording interval can be set between 1 second and 1 hourRecording interval can be set between 1 second and 1 hour
SD card InterfaceSD card Interface
Power and the power factor for each phase are shownPower and the power factor for each phase are shown
Data checkData check
Double power supply system via AC line and batteriesDouble power supply system via AC line and batteries
Windows software for data analysis and setting via USB portWindows software for data analysis and setting via USB port
Real time & remote measurements using Android™ applicationReal time & remote measurements using Android™ application
Data can be saved on SD card or transferred to a PCData can be saved on SD card or transferred to a PC
FeaturesFeatures
Various measurements by using applications for PCs and Android™ devicesVarious measurements by using applications for PCs and Android™ devices
【
System requirements
】
OS: Windows
®
8/10
Display: XGA(Resolution 1024×768 dots) or more
Hard-disk: space required 1Gbyte or more
Other: With CD-ROM drive and USB port
.NET Framework (3.5 or more)
* Windows
®
is a registered trademark of Microsoft in the United States.
Data saved on: SD card
Internal
memory
Capacity 2GB 3MB
Instantaneous measurement 6,670,000 10,000
Integration / demand
measurement interval
1 sec. 17 days 33 minutes
1 min. 992 days 33 hours
30 min. 3 years or more 42 days
Max number of file 511 4
To Next Page
Loading...
