Kyvol Cybovac E31 - Page 40

40
Step 4:
Tap Done close the page, then tap DISCOVER DEVICES to discover the robot which has
been connected in Kyvol APP.
Step 5:
After the robot is discovered, please tap CHOOSE DEVICE to set up your device.
Step 6:
Tap and allow Alexa APP to access the microphone of your mobile device.
Then you can say the following voice commands to your mobile device, the robot will
respond accordingly.
“Alexa, turn on the robot (or your robot´s name if you changed the device name.)”
“Alexa turn off the robot.”
Note:
If you have an Echo device at hand, please follow the steps below to make it available for
voice commands.
Step 1:
Log in to you Echo device with the same Amazon account for logging into Alexa APP.
Step 2:
Tap Device on the bottom, then tap Echo & Alexa to show your Echo device. Then you
can speak the voice commands mentioned above, and the robot will respond
accordingly as well.
Control the Robot with Google Assistant
Important:
1. Make sure the robot has enough power and the Power Switch of the robot is
pressed to ON.
2. You have connected the robot to Kyvol APP.
3. Make sure you´ve installed Google Home APP on your mobile device.
4. Make sure WiFi connection is stable.
Step 1:
Launch Google Home APP, then follow the in-app instruction to set up your Google
account.
Step 2:
Tap Settings on the main page, then scroll down to the bottom to tap Work with Google.
Step 3:
Tap on the upper right corner, then search and select Kyvol Home.