41
Step 4:
Enter the email address and password for logging in to Kyvol APP.
Step 5:
Tap Link Now and Authorize, it will show you Kyvol Home is linked.
Step 6:
Follow the instruction to set up the device to finish settings.
Step 7:
Tap and allow Google Home to access the microphone on your mobile device.
Then you can say the following voice commands to your mobile device, and the robot
will respond accordingly.
“OK Google, turn on the robot(or your robot´s name if you changed the device name).”
“OK Google, turn off the robot.”
“OK Google, robot go home.”
“OK Google, where is the robot.”
Note:
If you have a Google Home Speaker at hand, please follow the steps below to make it
available for voice commands.
Step 1:
Plug your Google Home Speaker into the socket.
Step 2:
Tap + on the upper left corner of the main page, then select Set up device.
Step 3:
Tap Set up new devices, then tap Next to look for devices.
Step 4:
Follow the instructions of Google Home APP to connect your Google Home Speaker to
WiFi.
Then you can speak the voice commands mentioned above, and the robot will respond
accordingly as well.
To Next Page
Loading...