10 | Page
2.
Press the ALARM button to confirm and move to the minutes. The alarm minutes will
flash. Press the + or - buttons to set the minutes.
3.
Press the ALARM button to confirm and move to snooze duration. The snooze time will
flash and start at the preset of 10 minutes. The date area will read “SNOOZE”
4.
Press + or - buttons to set Snooze Duration. Increase or decrease in 5 min intervals up to
120 min.
5.
Press and release the ALARM button to confirm and exit.
Note:
Alarm is crescendo sound. When the alarm sounds, it continues for 2 minutes and then
shuts off completely.
DEACTIVATE / ACTIVATE ALARM
1.
From normal time display, press and release the ALARM button to activate or deactivate
alarm.
2.
Alarm time will show for 3 seconds (with or without bell icon) in Extra Sensor area.
Everything else disappears on screen.
3.
Alarm icon will show when active and disappear when deactivated.
•
Alarm icon will flash when alarm sounds.
•
When alarm sounds, press any button except for SNOOZE/LIGHT to stop ringing for
one day
SNOOZE
•
When alarm sounds, press SNOOZE/LIGHT button to stop the alarm and activate SNOOZE
function. SNOOZE - duration will show in date area. Alarm icon will flash.
•
During snooze count down, press any button except for SNOOZE/LIGHT to exit snooze
count down
•
During snooze count down, press SNOOZE/LIGHT only to change backlight
•
When snooze alarm sounds, SNOOZE – duration “0m 00” will flash. Station beeps for 2
minutes then returns to normal display or press any button to stop ringing and return to
normal display. Press any button except for SNOOZE/LIGHT to stop alarm and exit snooze
function.
•
Repeat: When snooze alarm sounds, SNOOZE – duration “0m 00”” will flash, for up to 2
minutes with alarm sounding. Press SNOOZE/LIGHT button to stop the sound and
activate the snooze function again.
To Next Page
Loading...
Need help?
General
