Page| 17
WIND GUST ALARM
1. The wind gust alarm display will show.
2. Press and hold the SET button for about 2 seconds. The wind gust
digit will flash.
3. Press the ▲/DATE button or ▼/RAIN button to set the wind gust
alarm value.
4. Press the ALARM button to confirm the setting. The digit will stop
flashing.
5. Press the SET button to switch on or off the alarm. The
icon
indicates the alarm is switched on.
6. Press the ALARM button to move to the wind direction alarm.
WIND DIRECTION ALARM
Multiple wind direction alarms can be set simultaneously if desired.
1. The wind direction alarm display will show.
2. Press and hold the SET button for about 2 seconds. The wind direction
arrow on the outside of the compass circle will flash with the
corresponding compass direction or degrees reading displayed in the
center of the compass.
3. Press the ▲/DATE button or ▼/RAIN button to move the wind direction
alarm pointer.
4. Press the SET button to set a wind direction alarm value. A pointer icon
will appear inside of the compass circle to indicate an alarm setting for
that wind direction.
5. To remove an alarm setting for a wind direction, press the SET button again to remove the
selected wind direction alarm. The arrow icon inside the compass circle will disappear.
6. If more than one wind direction is desired as an alarm setting, Press the ▲/DATE button or
▼/RAIN button to move the wind direction alarm pointer to the next desired setting.
7. Press the SET button to confirm the next wind direction value. A pointer icon will appear inside of
the compass circle to indicate an alarm setting for that wind direction. You can set as many wind
direction alarms as you desire.
8. Press the ALARM button to confirm the setting. The digit will stop flashing.
9. Press the SET button to switch on or off the alarm. The
icon indicates the alarm is switched
on.
10. Press the ALARM button to move to the 24-hour rainfall alarm.
24 HOUR RAINFALL ALARM
1. The 24-hour rainfall alarm display will show.
2. Press and hold the SET button for about 2 seconds. The 24-hour
rainfall digit will flash.
3. Press the ▲/DATE button or ▼/RAIN button to set the 24-hour
rainfall alarm value.
4. Press the ALARM button to confirm the setting. The digit will stop
flashing.
5. Press the SET button to switch on or off the alarm. The
icon
indicates the alarm is switched on.
6. Press the ALARM button to exit the alarm setting mode.
HYSTERESIS
To Next Page
Loading...
Need help?
General
