3. When the batteries are inserted, all the segments of the LCD will light up briefly and a “beep” will
sound. The Projection clock will now start receiving the DCF time signal. After approximate 3 to 5
minutes, the DCF time will be displayed.
4. If reception is not successful within approximately 7-10 minutes, the Projection clock will attempt to
receive the signal in the next following hour.
Your Projection clock is now operational.
Note:
If the batteries are used as the main power source:
1. Projected image brightness, alarm volume and back-light strength would be weaker.
2. Battery life time would be much less than 1 year.
TO USE THE PROJECTOR POWER ADAPTER
The unit comes with an adapter unit for using the projector for an extended period of time, such as
throughout the night.
To install the adapter:
Important!
Make sure that your household voltage is 230V! Otherwise your Projection clock may be
damaged.
17
To Next Page
Loading...
