6. Unpacking and visual checks
LUCIA Operation Manual rev 1.0.0
7
6. Unpacking and visual checks
Every Lab.gruppen amplier is carefully tested and inspected before leaving the factory and should arrive in perfect
condition. If any damage is discovered, please notify the shipping carrier immediately. Save the packing materials
for the carrier’s inspection and for any future shipping.
7. Installation
7.1. Wall mounting
For attaching brackets (marked “B” on the drilling guide; see inside the shipping box) to the wall, please use
appropriate means for mounting to a specied load of 3 kg minimum on each screw. Ensure that all four screws
are secured properly to the wall. For drywall mounting, use a woodscrew (3.5 mm diameter with 25 mm minimum
length) and 4.5 mm drywall plug with specied maximum load of greater than 3 kg (e.g. Molly E22412). This
method of mounting is evaluated for North America according to UL/CA60065.
For mounting on surfaces other than drywall, please ensure that the method of mounting is suitable for the wall
material. Also, be certain that the brackets are secured to the wall with the appropriate means to ensure similar
load condition as specied previously. To attach the wall brackets “B” to your amplier, please use the supplied
3 mm Torx machine screws.
7.2. Rack shelf mounting
The amplier can be mounted to a rack shelf or similar by means of the three holes in the bottom marked “A” on
the drilling guide (see inside the shipping box). Use a 4 mm diameter machine screw (not supplied), ensuring that
the length of the screw is suitable for the thickness of the shelf. The screws used should not penetrate into the
amplier for more than 10-20 mm after mounting.
7.3. Lab.gruppen rack shelf kit
A special dedicated rack mount shelf designed to hold two LUCIA ampliers is available from Lab.gruppen as an
accessory. It includes all necessary accessories, screws, and mounting instructions.
To Next Page
Loading...
Need help?
General
