7. Installation
18
PLM+ SERIES Quick Start Guide rev 3.0.2
6.2. Lake Processing Features
• Lake’s exclusive classic/linear-phase/FIR speaker processing platform with four throughputs
• Group control with Raised Cosine™ MESA EQ™ asymmetric fi lters
• LimiterMax™ peak and RMS limiters
• Extensive loudspeaker preset database (Lake LoadLibrary™)
• Comprehensive clocking management system with low latency sample rate conversion
• Full support for Dante Controller
• Multiple and redundant inputs with programmable failover
• Four “Lake Class” analog inputs with Iso-Float™ ground isolation
• Two AES3 digital inputs (4 audio channels)
• Eight dual-redundant Dante network audio inputs
• Comprehensive 3rd party protocol for integration potential with third- party matrix systems via purpose-
developed middleware
7. Installation
7.1. Unpacking
Carefully open the shipping carton and check for any damage to the device or the supplied accessories. Every
Lab.gruppen product is tested and inspected before leaving the factory and should arrive in perfect condition. If
any damage is discovered, please notify the shipping company immediately. Only the consignee may initiate a
claim with the carrier or their insurers for damage incurred during shipping. Save the carton and packing materials
for the carrier’s inspection.
7.1.1. Included in the box
In addition to the PLM+ device, the shipping carton includes the following items:
• PLM+ Quick Start Guide (this document)
• AC mains lead (power cable) with Neutrik® powerCON® connector (PLM20K44 and PLM12K44 only)
and AC socket plug according to ordering selection. PLM5K44 uses a locking IEC connector.
• Rear brackets for additional rack support (pair) along with associated mounting hardware.
Please keep the original carton and associated packaging to facilitate shipping of the device should the need arise.
To Next Page
Loading...
Need help?
General
