Lab.gruppen PLM+ Series User Manual

15. Technical Specifi cations
PLM+ SERIES Quick Start Guide rev 3.0.2
37
15. Technical Specifi cations
44K02 MLP44K21 MLP44K5 MLP
5000 W
W 00002W 00021
900 W
W 0044W 0003
1250 W
W 0005W 0003
1250 W
W 0044W 0003
1250 W
W 0032W 0091
700 W
W 0511W
059
1300 W
W 0033W 0003
1250 W
W 0074W 0003
900 W
W 0044W 0044
1250 W
W 0095W 0095
1750 W
W 0064W 0064
1350 W
W 0032W 0032
700 W
W 0511W 0511
1450 W
W 003
3W 0033
2000 W
W 0074W 0074
150 V
V 491V 491
30 A
A 76A 76
Lake / Dante
4
rewop tuptuo lennahc elgnis xam eht reviled ot laitnetop sa
h lennahc ynA)MPR( tnemeganaM rewoP lanoitaR
V 491V 571V 741
,)CD( noitcetorP tnerruC tceriD ,)FHV
( no
itcetorP ycneuqerF hgiH yreV ,)LAC( retimiL egarevA tnerruCserutaef noitcetorP
Short Circuit Protection, Current-Clip Limiter, Voltage Clip Limiter, Temperature protection
< 0.05 %
% 50.0 <% 50.0 <
< 0.04 %
% 40
.0 <% 40.0 <
> 112 dB
Bd 411 >Bd 411 >
> 70 dB
Bd 07 >Bd 07 >
+ /- 0.05 dB
Bd 50.0 -/+Bd 50.0 -/+
96 KHz / 32 bit floating point
96 kHz / 32 bit floating point 96 kHz / 32 bit floating point
1.61 / 1.68 ms
sm 86.1 / 16.1sm 86.1 / 16.1
General
Processing / Network
Numbers of amplifier channels
Total burst power all channels (share among channels with RPM)
Max. O
utput Power (all ch.’s driven)
1)
2 ohms
2.67 ohms
4 ohms
8 ohms
16 ohms
Hi-Z 70 V
Hi-Z 100 V
Max output power single channel
1)
2 ohms
2.67 ohms
4 ohms
8 ohms
16 ohms
Hi-Z 70 V
Hi-Z 100 V
Amplifier output modules (all models, all channels)
Peak output voltage
Max output current
Default voltage limitation (can be lifted with RPM configuration
Audio Performance (Amplifier platform with digital input)
THD + N 20 Hz - 20 kHz for 1 W
THD + N at 1 kHz and 1 dB below clipping
Dynamic range
Channel separation (Crosstalk) at 1 kHz
Frequency response (1 W into 8
ohm, 20 Hz - 20 kHz)
Internal sample rate / Data path
Product propagation delay AES 96 kHz / analog input
Lake processing
sretimil SMR dna kaep - ™xaMretimiL ,yaled ,QE ,revo-ssorc RIF/esahp-raenil/cissalC
fo seludom 4 ot pUgnissecorp rekaepsduoL
System tuning Group control with Raised Cosine™ MESA EG™ asymmetric filters
Input redundancy / Matrix Automatic 4 level input redundancy / 4 input mixers
System integration Comprehensive 3rd party protocol over UDP Ethernet
Measurement & Ana
lysis
Pilot tone generation and analysis
Yes
Load impedance analysis
Yes
Real Time Analyzer (RTA), 3rd party integration
Yes
Dante Audio Network
Dante I/O
8 X 8
Network topology / redundancy
Flexible topology / Supports daisy-chained and Dual redundant networks
Sample rates / transport
48, 96 kHz / Uni + Multicast
Network latency
0.25, 0.5, 1.0, 2.0, 5.0 ms
Device Presets
100
tcudorp eht fo sgnittes eht rof snoitacol yromem lacoL
AES Inputs
Inputs
4 AES inputs
Supported sample rates/ resolution
44.1, 48, 88.2, 96, 176.4,
192 kHz / up to 24 bits
Sample rate conversion THD + N 20 Hz - 20 kHz unweighted
0.00003 %
Analog Inputs
Inputs 4 high quality inputs with Iso-Float™ ground isolation
Maximum input / digital reference
+ 26 dBu / +21 dBu
Sampling rate / resolution
96 kHz / 24 bit
Input impedance bala
nced / unbalanced
20 k / 10 k ohm
THD + N (typical at 1 kHz unweighted)
0.00022 %
THD + N (typical at 20 Hz and 20 kHz unweighted)
0.00033 %
Limiters
Adjustable Inter-Sample Voltage Peak Limiter (ISVPL)
17.8 - 150 V, step size 0.1 V
17.8 - 194 V, step size 0.1 V 17.8 - 194 V, step size 0.1 V
Current Peak Limiter < 300 ms
30 A peak
kaep A 76kaep A 76
Current Average Limiter (CAL) > 300 ms
15 Arms
Arms 33Arms 33
LimiterMax (rms and peak limiters)
MaxRMS (rms voltage limiter)
Yes
MaxPeak (peak voltage limiter)
Yes

Lab.gruppen PLM+ Series Specifications

General

Total Output Power	Up to 20, 000W
Networking	Ethernet
DSP	Yes
Input Connectors	XLR
Output Connectors	Neutrik speakON
Dimensions	Varies by model
Weight	Varies by model
Protection	short circuit, DC