22
Product Service Domestic 1-800-522-7658, International 816-333-8811
Chapter 4: Using Your CentriVap
CentriVap Controls
The control panel for the CentriVap is shown below
with a description about its function.
1. Display – The liquid crystal display (LCD) shows
set point parameters and actual measured
conditions.
2. Program Buttons – Used to initiate the start of a run
with the use of just one button.
3. Run/Stop Button – Used to start or stop a run.
4. Preheat Button – Used to turn on the heater to
preheat the chamber prior to loading samples.
5. Increase Button – When pressed, the last selected
set point will increase.
6. Decrease Button – When pressed, the last selected
set point will decrease.
7. Set Point Select Button – To select a parameter to
change, press the select button. Arrows on the
display will point to the parameter that may be
altered.
8. Heat Boot Button (not shown) – If the model is so
equipped, pressing the button will activate or
deactivate the auxiliary Heat Boost heater.
3
2
1
6
7
To Next Page
Loading...
