LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
01/01/2022 Model LM1012TTS
REPLACING THE MAIN POWER FUSE
The circuitry is protected from a current overload by GMA 2A a slow blow fuse. Should the applicator fail to operate, the
condition of this fuse should be checked. If the fuse is open, the cause of the overload condition must be determined
and corrected prior to replacing the fuse. NEVER replace the fuse with one of a greater amp rating. The specified rating
has been selected to prevent damage and/or injury.
ACTIONS TO REPLACE THE MAIN FUSE
1. Set the main power switch to the OFF position.
2. Disconnect the AC power cable from the rear of the console.
3. Locate the fuse holder/power cord assembly.
4. Gently press down the fuse holder cover while pulling away from the console.
5. Replace with the spare fuse provided in the holder.
To Next Page
Loading...