LM-3605 Dynamic Label Applicator
USERS MANUAL
Page 29 Made in the U.S.A.
PROGRAMMING
All programming is performed via the HLI-100 keypad and display as shown on page 2-6. All programmed settings
are backed in nonvolatile memory and are not lost when the unit is powered off.
Upon power up of the control, the screen will display MODEL NUMBER & REVISION of the HLI-100 and then the
MODEL NUMBER & REVISION of the labeler control. After this, the screen will now display the counter, TOTAL
XXXXXXX.
• KEY FUNCTIONS:
“PROG” PROGRAM KEY IS USED TO:
1. Enter and exit the program menu.
“ENTER” KEY IS USED TO:
1. Access or “Enter” the selected “PROGRAM BLOCK”. (example PRODUCT SENSOR or TAMP SETUP)
2. Access or “Enter” the data selection/options line (bottom line of display) of the “PROGRAM BLOCK”
Sub Menus.
3. Store the selected data.
UP / DOWN ARROW KEYS ARE USED TO:
1. Scroll up & down through the primary menu “PROGRAM BLOCKS” . (Header name)
2. Scroll sub menus inside of “PROGRAM BLOCKS”. (top line of display while IN a “PROGRAM BLOCKS”)
3. Increment and decrement programmable values.
4. Select different display views while in the “RUN” mode.
Left / Right ARROW KEYS ARE USED TO:
1. Move the “up carrot” left or right when programming a value.
START / ENABLE KEY:
1. Start key will initialize the application cycle.
2. Enable key will “Enable” the drive after it has been disabled.
CLEAR / STOP KEY:
1. Stop key will abort the cycle only when not in the program menu.
2. Clear key will delete stored values while in the edit mode.
3. Clear key will disable the drive.
ESC (escape) KEY:
1. Will back out of the sub programming menu without saving changes.
3-01
To Next Page
Loading...