LabelMill LM3605 - Page 31

LM-3605 Dynamic Label Applicator
USERS MANUAL
Page 31 Made in the U.S.A.
© 2019 LABELMILL
12/01/2019 Model LM3605
• COUNTER
Used to reset the internal counter of the control.
• PRINT TYPE
The print type command is used to activate the print repeat cycle in the supplied print engine. This feature will
continue to print the last label in the buffer after the buffer count has expired.
PROGRAMMABLE BLOCKS:
Reprint – Turns reprint option ON or OFF
Serial End – On or Off / sends a serial command out comm. #1 serial port(ESC / D / CR) at the “End of Cycle”.
Char-1 ESC 27 decimal
Char-2 D 68 decimal
Char-3 CR 13 decimal
• CYCLE TYPE
Cycle Type determines the application type and sequence in relation to the label feed.
PROGRAMMABLE BLOCKS:
Tamp Before Feed – (standard) Tamps label first, prints label second
Tamp After Feed – Prints label first, tamps label second
Blow Before Feed – Blows on label first, prints label second
Blow After Feed - Prints label first, Blows on label second
Pre-Print Tamp – *see below*
Pre-Print Blow – *see below*
Clamshell Before Feed – Clamshell applies label first, prints label second
Clamshell Before Feed – Prints label first, clamshell applies label second
• JOB STORAGE
Used to store frequently used settings pertaining to different labeling jobs.
PROGRAMMABLE BLOCKS:
SAVE JOB – stores settings for active job.
RESTORE JOB – Restores saved job.
• DEFAULT SETTINGS
This setting will return the controller to the default settings.
• I/O STATUS
Displays the status of the inputs and outputs
3-03