LabelMill LM3605 - Page 5

LM-3605 Dynamic Label Applicator
USERS MANUAL
Page 5 Made in the U.S.A.
© 2019 LABELMILL
12/01/2019 Model LM3605
SPECIFICATIONS
PRINT SPEED
Up to 12”/second and approx. 60 labels/min.
(Varies depending on label and product size.)
BAR CODES
Linear and Two-Dimensional Barcodes
BAR CODE RATIOS
1:2, 1:2.5, 1:3 or individually programmable bar code widths
HUMAN READABLE FONTS
OEM Standard Fonts, Firmware Support for Downloadable TrueType
Fonts, and Additional Fonts Available
LABEL ROLL CAPACITY
12” Max. outside diameter wound on a 3” diameter core. Die cut waste
removed with a minimum of 1/8” separation between labels in running
direction.
LABEL SIZE
Minimum: 0.625” wide x 0.50” long
Maximum: 6.6” wide x 39” long
MAXIMUM PRINT AREA
6.6” wide x 39” long
(Varies dependent upon system configuration)
LABEL PLACEMENT
ACCURACY
Up to + or - 1/32” (1mm) when labels are produced to specifications
and product handling is controlled.
PRINTING METHOD
Thermal Transfer or Direct Thermal
Right-Hand or Left-Hand
INTERFACE
Standard Centronics Parallel Port
Standard RS-232C Serial Port, Ethernet port, USB
INTERFACE SENSORS
Ribbon out
Product Sensor-Photo Eye-Limit Switch
PLC input
ELECTRICAL
115V AC/60 Hz-250 W idle, 600 W running.
AIR REQUIREMENT
80 p.s.i./3 cfm
SIZE
23” T x 30” W x 23-3/8” D
ENVIRONMENT
Operating Temp. 50-95 F (10-35 C)
15-85% RH. non-condensing
WEIGHT
60 lb. (with U-Arms)
*Options available
1-02