LabelMill LM3605 - Page 51

LM-3605 Dynamic Label Applicator
USERS MANUAL
Page 51 Made in the U.S.A.
© 2019 LABELMILL
12/01/2019 Model LM3605
FAULT MESSAGES
DISPLAYED FAULT
FAULT
CORRECTIVE ACTION
Memory Checksum
Data lost in serial EEPROM
Consult factory or service provider
Print Time Out
Printer failed to print or
Control failed to receive a “End
Print Signal”
A. Printer Off Line
B. No Label Formats Loaded
C. Check Printer Interface Cable
D. Printer mode incorrect
Tamp Down FLT
Head up limit switch failed to
switch during the tamp cycle.
Cylinder did not move off of reed
switch.
A. Tamp Cylinder Is Not Up
B. No Air
C. Faulty Valve
D. Flow Control Miss Adjusted
E. Miss Adjusted Reed Switch
F. Faulty Reed Switch
G. Tamp duration too small
H. Check programming of Tamp switch
NOTE: Light on reed switch should be on when
cylinder is up
Head Down
Head up limit switch failed to
switch during the tamp cycle.
Cylinder did not return up.
A. Tamp Cylinder Is Not Up
B. No Air
C. Faulty Valve
D. Flow Control Miss Adjusted
E. Miss Adjusted Reed Switch
F. Faulty Reed Switch
G. Tamp duration too small
H. Check programming of Tamp switch
NOTE: Light on reed switch should be on when
cylinder is up
2
nd
Trigger FLT
Trigger signal was not received
before timer expired. This FAULT
will only occur if “Variable Data”
feature is “ON”.
A. Check photo eyes
B. Check product delay
Ribbon Out
Printer is out of ribbon
Check printer for ribbon
Low Ribbon
Printer is low on ribbon
Check printer for ribbon
Label Out
Printer is out of ribbon
Check printer for label stock
4-02