Labwit ZWYC-290A - Operating under Programmable Control Mode

Ultimate-cell Stackable Shaking Incubator V2017.2
31
To set the lighting outputs of under "Fixed Value" control mode,
 Press "SET" in the home page
 Press "LIGHTS" in the "SET" page to start setting the photosynthetic lighting
system
 Press the switch to switch the control mode to "FIXED"
LIGHT-RED — Red Light Output button
Press it and use the keyboard to enter the red light output set value, and press “OK”
to confirm and save. Set range 0-100%.
LIGHT-BLUE — Blue Light Output button
Press it and use the keyboard to enter the blue light output set value, and press “OK”
to confirm and save. Set range 0-100%.
 Switch the "LIGHT MODE" in the "SET" page to "FIXED " mode.
 Press "LIGHT" switch in the home page to switch "ON" the lighting system.
 Press the switch again to switch "OFF" the lighting system.
6.5.2 Operating Under Programmable Control Mode
With the "Programmable" control mode, the photosynthetic lighting system can sim-
ulate and run day/night cycles. Together with the other operating parameters, the
incubator can create reproducible conditions of "natural" environment.