d2 USB 3.0 User Manual 9
LED BUTTON
The LED is a button that can be used to power off/on the LaCie d2.
Power off
Follow the steps below to turn the device off:
Make certain that the LaCie d2’s volumes are not being accessed.1.
Eject the LaCie d2’s volumes. See Unmounting Your Hard Drive for instructions. Once the volumes have been2.
properly ejected, the LaCie d2 enters power-saving mode.
Apply a long press, a minimum of four seconds, to the LED button. The LED turns solid blue before turning off.3.
Power on
In most instances, the LaCie d2 powers on automatically when connected to a computer and an active power
source. However, the LED button can be used to power on the device if the following two conditions are met:
The LaCie d2 was powered off using a long press
■
The LaCie d2 remains connected to the computer’s USB port and an active power source
■
To power on the LaCie d2, push the LED button for one second.
To Next Page
Loading...
