34
www.howdens.com
The cut down pieces of rail are used to hold the back
panel in place.
Don’t cover the gap that has been cut for the ducting.
114mm
485mm
6x 30mm Wood screw
(not supplied)
=
=
2x 485mm
Insert batten at the back of the
cabinet to support worktop
Remove back rail
Split back rail into 2 long sections (shown below)
*
30mm
5
Fit back panel supports to the cabinet sides
6.Installation-Modicationsrequiredfora600mmcabinet with door frontal
4
Remove and cut down back rail Avoid metal tangs on wider cabinets.
To Next Page
