11
6 Operation
6.1.6 Displaying the Running Time Meter
The total of running times for curve set 1and curve set 2 do not necessarily add up to the dis-
played total running time.
NOTICE
The total counter refers to the ETAMATIC 's running time. It starts timing as soon as the unit
is connected to a voltage source (this also provides the basis for the fault history).
The individual running time counters refer to the burner's running time. They start timing as
soon as the burner is in operation with the relevant curve set (flame signal is present).
press key 10 the display shows the running text of the following data succes-
sively:
Total running time
Running time on curve set 1
Starts on curve set
Running time on curve set 2
Starts on curve set 2
Running time on curve set 3*
Starts on curve set 3*
Running time on curve set 4*
Starts on curve set 4*
* if p
arameterised
To Next Page
Loading...
Need help?
General
