EasyManuals Logo

Lamtec ETAMATIC Quick Reference

Lamtec ETAMATIC
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
18
8 Appendix
Fault
Code
No.
Restart according to Description
TRD EN676
601 0 0 Leak check fault: gas pressure still applied.
602 0 0 Leak check fault: gas pressure missing.
603 0 0 Vent gas line manually.
605 >88 3 Oil pressure < min !!!
606 1 1 Gas > min appears in oil operation.
608 0 0 Boiler safety chain dropping.
609 1 1 Gas safety chain dropping.
610 >88 3 Oil safety chain dropping.
611 >88 3 Gas pressure too low
612 1 0 Gas pressure too high.
613 0 0 Air pressure signal missing.
616 1 1 Ignition flame goes out in standby operation
617 1 1 Continuous ignition flame goes out under operation
623 0 0 Atomizer switch-ON-pre-period not kept
624 >88 3 Oil pressure too low
625 >88 3 Oil pressure too high
626 >88 3 Atomizer air pressure too low
702 0 0 Flame signal appears during pre-ventilating.
711 0 0 Illegal operating mode change
713 0 0 Incorrect signal combination in operating mode AU
714 0 0 Incorrect signal combination in operating mode BE
715 0 0 Incorrect signal combination in operating mode VO
716 0 0 Incorrect signal combination in operating mode ZP
717 0 0 Incorrect signal combination in operating mode ZU
719 0 0 Fuel valves open too long without flame
720 0 0 Ignition transformer switched on too long
721 0 0 Ignition valve open too long
723 0 0 Ignition process taking too long
724 0 0 Gas valves open when burning oil
725 0 0 Oil valves open when burning gas
726 0 0 Main gas 2 open without main gas 1
727 0 0 Main gas 1 illegally open
728 0 0 Main gas valves and ignition valve open too long
729 0 0 Ignition process taking too long (without pilot burner)
731 0 0 Ignition valve opened without ignition burner
732 0 0 Incorrect signal combination during operation
733 0 0 Incorrect signal combination after operation
734 0 0 Pre-ventilating time not complied with
736 0 0 Leak check: both gas valves open
737 0 0 Seal tightness check: Main Gas 2 delayed for too long at deactivation.
738 0 0 Leak check: main gas 2 missing
739 0 0 Seal tightness check: Main Gas 2 open for too long.
740 0 0 Seal tightness check: Main Gas 1 leaky.

Other manuals for Lamtec ETAMATIC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lamtec ETAMATIC and is the answer not in the manual?

Lamtec ETAMATIC Specifications

General IconGeneral
BrandLamtec
ModelETAMATIC
CategoryController
LanguageEnglish

Related product manuals