LANDA PDE • 8.913-997.0 • Rev. 02/12
7
PRESSURE WASHER
OPERATOR’S MANUAL
STEP 1: Attach the handle to the
frame of the pressure washer.
Note: It may be necessary to move
the handle supports from side to
side in order to align the handle
so it will slide over the frame sup-
ports.
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STEP 4: Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 9: Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
Alignment
Holes
Handle
Frame
Assy.
Carriage
Bolt
Nut
Studs
Nut
Hose/Gun
Storage
Bracket
Safety
Latch
Spray
Gun
High Pressure
Hose
Nozzle Extension
Spray
Gun/Wand
STEP 6: Before installing nozzle,
turn on water supply and run
machine allowing water to flush
through the system until clear.
Cold
Water
Source
Garden
Hose
Bolts
STEP 10: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
Pressure
Nozzle
Wand
Coupler
Wand
Collar
STEP 7: Connect the high pres-
sure hose to the pumps discharge
nipple. Push coupler collar forward
until secure.
Discharge
Nipple
High
Pressure
Hose
Coupler Collar
STEP 8: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
Pump
Water
Garden Hose
To Next Page
Loading...
