EFFECTS EDIT NOTES
The Effects edit chart shows the parameters that can be edited in each of the effects.
Edit refers to the Edit rotary control. In many cases this function is duplicated with the TAP button edit.
Example:
Chorus +Delay
This Effect combination can be adjusted in the following ways:
1) Chorus Rate/Speed. (Modulation Frequency)
Simply turn the Edit control to adjust.
Or use the TAP tempo button.
You can store your change for future use by pressing and holding the Live button until the store light flashes.
2) Chorus Depth. (Modulation Depth)
Hold down A Edit button for 1 second and then turn Edit control.
Whilst button A remains lit you are still in edit mode. (Remains in Edit mode for 3sec after edit)
You can store your change for future use by pressing and holding the Live button until the store light flashes.
3) Delay Time
Hold down Tap button for 1 second and then turn Edit control. Whilst button A remains lit you are still in edit mode.
(Remains in Edit mode for 3sec after edit)
You can store your change for future use by pressing and holding the Live button until the store light flashes.
4) Delay Mix
Hold down Tap button for 1 second and then turn Edit control.
Whilst button B remains lit you are still in edit mode. (Remains in Edit mode for 3sec after edit)
You can store your change for future use by pressing and holding the Live button until the store light flashes.
5) Delay Repeats
Hold down Bypass button for 1 second and then turn Edit control.
Whilst button B remains lit you are still in edit mode.
You can store your change for future use by pressing and holding the Live button until the store light flashes.
(Note if a Boost is set this will be stored to the Live Channel at the same time)
To Next Page
Loading...
