WiBox2100E User Guide 19
3
3
:
:
Q
Q
u
u
i
i
c
c
k
k
S
S
t
t
a
a
r
r
t
t
This chapter describes installation procedures for the WiBox units.
Required Information
Hardware Address
Take note of the unit’s hardware address (also known as MAC address). It is on the
product label, in the format: 00-20-4a-XX-XX-XX, where the XXs are unique numbers
assigned to the product.
Hardware Address: 00-20-4a-_____-_____-_____
IP Address
The WiBox must have a unique IP address on the network. The systems
administrator generally provides the IP address, subnet mask, and gateway.
IP Address: _______ _______ _______ _______
Subnet Mask: _______ _______ _______ _______
Gateway: _______ _______ _______ _______
WLAN Settings
Before the WiBox can communicate on an 802.11b/g wireless network, the WLAN
settings must match the wireless network. By default, the WiBox is set to Ad Hoc
network mode, and its wireless Network Name (SSID) is LTRX_IBSS.
You can configure either WEP or WPA settings:
Note: WPA Security is only available in infrastructure mode.
To Next Page
Need help?
General