EasyManuals Logo

Lantronix Ethernet User Manual

Lantronix Ethernet
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Setup Mode: Advanced Settings
WiBox2100E User Guide 72
Default Settings
Select 7 Default Settings from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, Security, and Expert settings to the factory
default settings.
The server configuration settings for IP address, gateway IP address, netmask, and
WLAN remain unchanged.
Defaults for all settings are listed below.
Channel 1 Configuration
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No
10001
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter
3
Hostlist Retry Timeout
250 (msec)
Send Character
0x0D (CR)
All other parameters
0
Channel 2 Configuration
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No
10002
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter
3
Hostlist Retry Timeout
250 (msec)
Send Character
0x0D (CR)
All other parameters
0
WLAN Settings
Enable WLAN
Y (Yes)
Topology
1 (AdHoc)
Network Name
LTRX_IBSS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix Ethernet and is the answer not in the manual?

Lantronix Ethernet Specifications

General IconGeneral
BrandLantronix
ModelEthernet
CategoryNetwork Card
LanguageEnglish