16
3 - Power ON
Note: The ALTITRACK must be switched ON prior to entering the airplane
Press Right or Left Front Button until “ACCESS” and
“LOW BAT” flashes. Then release the button.
The ALTITRACK can be used for jumping, if:
- The pointer moves from “6” to “0”.
- Battery capacity is sufficient.
The ALTITRACK MUST NOT be used for jumping, if:
- The LCD on the rear side displays an Error code
(ex.: ERR2, ERR3, ERR4, ERR5, ERR100).
- The unit sounds a beep every minute.
- Battery capacity is insufficient.
Fig.5–PowerON
Battery status
To Next Page
Loading...
