59
17 - Operational Hints and Trouble-shooting
When the ALTITRACK detects a fault, an error (“ERR”) symbol and trouble shooting
numbers 2 to 5 and 100 are displayed in the upper part of the LCD screen. At the same
time the unit beeps every minute.
The “ERR” trouble shooting codes are as follows:
ERR 2 (transducer defective)
ERR 3 (transducer out of range)
ERR 4 (crystal defective)
ERR 5 (memory communication error)
ERR 100 (memory defective)
Remedy: perform reset
If the unit still does not function correctly even after performing reset and replacing the
battery, then perform following:
Press and hold while resetting.
The ALTITRACK resets to factory settings and sounds three beeps.
If the unit is still faulty, please contact LARSEN & BRUSGAARD.
To Next Page
Loading...
