Measure Height in 3-Shots:
This routine is ideal for at, vertical objects
that do not lean. To shoot through brush, use
the lter mode, foliage lter and a reector.
[1] Press until ( ) and ( ) ashes.
[2] Aim anywhere you have a clear line of sight and
press-and-hold ( ).
[3] ( ) Aim to top, then press-and-hold .
[4] ( ) ( ) Aim to bottom, press-and-
hold , ( ) ( ).
Measure Height in 2-Shots:
[1] Press until ( ), aim at top of target then
press-and-hold ( )t. Note value.
[2] Aim at the bottom of the target then press-and-hold
( )b. Note value and HT = VDt - VDb.
The 2-shot HT works well on
leaning objects but requires a
clear line of sight for both shots.
Helpful Tip:
To Next Page
Loading...
