EasyManuals Logo

Laser BLU-BD3000 User Manual

Laser BLU-BD3000
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
BLU-BD3000 User Manual
43 | P a g e
FAQ
In order to prolong the service life of your player, it is recommended to wait at least
30 seconds before you turn it on again after switching it off. Remove disc and turn
power off after operation. Some functions of the player may not be applicable to
certain discs.
Some discs with special features may not be fully supported by the player. This is not
a malfunction of the unit. In case of player malfunction, please turn it off, wait for 30
seconds and turn it back on.
Use the 2 charts below to resolve general operational problems. If there are any
problems that you cannot resolve, please contact Laser technical Support
Failure
Reason
and
solutio
n
No power supply
Please
make
sure
that
the
AC
outlet
has
electricity.
Insert the AC power line firmly. Press the Power key on
the front panel to turn on the player.
Image is frozen and
operation is invalid
Cut
off
the
power
supply
and
connect
again,
and
then
press the Power key on the remote control to restart
the
player.
Auto standby
The
default
setting
of
the
player:
in
stopped
state,
if
there is no operation in 5 minutes, the player enables
screen saver automatically; if there is no operation in 10
minutes in screen saver, the player enters standby
automatically. You can press the Power key on the
remote control to restart the player, or select “OFF” in
“Main menu General System – Screen saver”.
Remote control can’t
work normally
The
remote
control
isn’t
aimed
at
the
receiver.
Please
aim the remote control at the receiver on the front
panel.
There is obstacle between the remote control and the
player.
Please remove it.
Battery is too low. Please replace with new batteries.
Please refer to the instruction of “Using remote
control”.
Can’t play discs
Please
make
sure
that
the
label of
the
disc
is upwards.
If
the disc is dirty, please clean first.
The disc is empty or can’t be played. Please check
whether
the
area
code
of
the
disc
matches
the
player.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Laser BLU-BD3000 and is the answer not in the manual?

Laser BLU-BD3000 Specifications

General IconGeneral
BrandLaser
ModelBLU-BD3000
CategoryBlu-ray Player
LanguageEnglish

Related product manuals