Pico rigging manual 2007.doc Page 10 of 28
4) Untie the ends of the jib halyard and tie a figure of eight knot in the part that
goes through the cleat. Pull the non-cleated rope end out from under the sail at the
halyard exit point in the sail. Rethread the jib halyard throw the eye and back
down outside the sail. Tie the free end of the halyard to the end that has passed
through the cleat.
5) From your rope kit, find the rope marked Cunningham. Tie a bowline loop onto
the sail D-ring, thread around the cleat bridge, back up to the D-ring and down to
the cleat. Tie a bowline loop in the end of the rope and add a small amount of
tension.
To Next Page
Need help?
General
