Laser Pico User Manual

Pico rigging manual 2007.doc Page 27 of 28
If you intend to race your Pico you will have to attach your sail numbers. It is advised to
apply the sail numbers in a dry, clean and wind free environment.
1. Lay the sail on a flat surface port side up.
2. The numbers on the starboard side are always higher than the port side.
3. Measure 25mm above the “P” of the Pico screen print and draw the base line
perpendicular to the leach and blue sail panel
4. Measure 70mm from the leach and draw a line parallel to the leach and
perpendicular to the base line previously drawn.
5. Position the Port sail numbers starting with the last digit squared to the base and
leach lines.
6. The remaining numbers should be square to the previous number and 60mm
apart.
Turn the sail over and mark a line on the starboard side of the sail 100mm above the port
numbers. Starting with the first digit work from the leach line position the sail numbers
60mm apart as above.
100mm
70mm
25mm
60mm
5. Sail Number positioning – Standard sails

Laser Pico Specifications

General

Type	Dinghy
Crew	1-2
Designer	Jo Richards
Length	3.50 m
Hull weight	60 kg
Sail area	5.1 m²