4. Attach the gnav strut to the gnav anchor
point using the drop nose pin. (Articulating
toggle at the bottom with joint orientation as
shown)
5. Thread the mainsheet through the centre of the
block attached to the bridle rope and tie a half
hitch stopper knot.
6. Feed the mainsheet through the blocks and
to the mainsheet jammer as shown.
Tip - double check the mainsheet
passes through the switch-able ratchet
in the correct direction
Tip - Best seaman like practise would be
to tie the loose end of the mainsheet to
one of the rear toe straps to prevent
flailing and sheet falling overboard.
Sails
Jib
1. Ensure furling drum line is fully wound completely
onto furling drum before you attach the jib.
2. Unroll the jib and attach jib tack to furling
drum. Tape up pins on jib tack.
13
To Next Page
Loading...
Need help?
General
