Rigging And Raising The Mast
1. Unwrap the mast.
2. Ensure all the halyards are led to the
base of the mast and each halyard
rope end has a knot tied in it.
3. Insert blanking plugs, (tight fit to produce
seal) a medium size flat blade screwdriver
maybe required to fit.
4. If applicable, fit trapeze wires and
plugs in the top terminal positions on
the mast. (Note: Trapeze kit is an
option on the standard rig but is
included in the XD rig)
5. Fit spreaders (See next page for diagram)
6. Ensure that all the spreader pins and rings are taped up or serious
damage could occur to the sails.
9
To Next Page
Loading...
Need help?
General
