EasyManuals Logo

Laser VAGO User Manual

Laser VAGO
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
9. Furl the jib by pulling the furling line. The
furling line cleat is positioned on the front
beam port/left hand side.
Lower shroud tensioning
x After tensioning the jib halyard re-adjust the lower shrouds so that they
are just tight. It is essential that the mast is straight
before the
mainsail is hoisted (Fore and aft and side to side to side). Lower shroud
tension should be adjusted accordingly.
Gennaker
1. Temporarily tie the gennaker halyard to one of the lower shrouds. (Blue
halyard exiting from ¾ height up mast, just above the jib halyard sheave
box)
2. Ensure the end of the gennaker halyard taken from the
base of the mast is free of knots and tangles.
3. Take the gennaker halyard
from the base of the mast
and pass forward, under the
gennaker sock and round the
gennaker pole outhaul block.
(The gennaker pole outhaul
block is attached to the blue
rope led from the pole as
shown in the picture)
15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Laser VAGO and is the answer not in the manual?

Laser VAGO Specifications

General IconGeneral
BrandLaser
ModelVAGO
CategoryBoat
LanguageEnglish

Related product manuals