10
- It is forbidden to tighten the fixing nuts on the safety frame with intend to
increase its resistance against unwished switching off. Required force for
switching control should remain on values preset by the manufacturer, i.e. up
to 80 N in the lower horizontal frame part.
- Any removal of safety elements and guards from the machine and any further
operation without them are strictly forbidden.
- While chipping it is not allowed to enter the area of ejected flying wooden
chips. Every operator of this machine is fully responsible for any injury or
damage caused to the third persons within the operating reach of the machine.
- The end piece of the discharge duct (its upper turnable part) can be set only in
angles, see following figure. Never direct it toward the attendant's place!!
- While working the machine should fully rest on the ground with its frame
bottom part.
- Do not let the machine sink in ditches, trenches or similar undulations. It is
necessary to have flat surface around the machine while working and to keep
recommended loading heights.
- Keep this machine beyond children's and unauthorised person's reach. Avoid
their attendance while chipping.
- When using the chipper without any container or closed bin, keep anybody
beyond the area where chips are being thrown.
- When using the chipper with such a bin, never look inside if the chipper is still
working.
- When leaving the machine take always the switch key out of ignition.
- Every operator of this machine is fully responsible for any injury or damage
caused to the third persons within the operating reach of the machine.
To Next Page
Loading...