Laski LS 160 - Troubleshooting Bearing Issues and Waste Disposal; Bearing Overheating and Wear Solutions; Waste Disposal and Environmental Protection

Chipper LS 160T
50
Bearings overheated
Insufficient lubrication
or wrong lubricant used
Lubrication and lubricants should be in
accordance with recommended
intervals and sorts (LTA 3EP MOL
Lition)
Too high speed of
chipping wheel
Working speed of the chipping wheel
must not exceed 1500 rpm.
Bearing loosened
Tighten up bearing housing bolts with
required torque
Bearing worn
Replacement
Waste Disposal
Any waste materials resulting from the machine operation should be disposed
in accordance with laws and regulations applicable in the given country.
Protect nature and water resources against used oil and filter elements.
Any parts of the machine should be disposed in accordance with laws and
regulations applicable in the given country.