25
Use
Storage
Store the chipper always in a dry shelter to protect it against weather effects.
- During storage keep the switch key separately.
- Keep the stored machine beyond unauthorised persons reach.
- Before storage clean all parts of the machine. For cleaning use pressure water.
Should the water be in the chipping device space, wipe it off and let it dry.
- Clean especially oily spots.
- Exchange all damaged or worn parts. Use always original spare parts. For
spare parts contact your dealer or authorised services.
- Do not apply any grease or similar agents on elastic hydraulic hoses.
- Always put the machine aside on a flat and solid floor or on a wooden pallet
for further handling.
- Do not put any objects or tools on the machine.
Before Putting into Operation
- Before the first putting into operation check up the machine for contingent
damages and completeness after its transport and storage.
- Check tightening of bolted joints, especially guards, grids and completeness of
other parts.
- Check movability of turnable parts (discharge duct etc.).
- Check work safety labels for completeness and legibility. Replace any
damaged and illegible label, if necessary.
- Grease bearings and sliding parts.
- Check up the hydraulic oil level. While being cold, the oil level should be
between the MAX and MIN marks on the oil tank gauge.
To Next Page
Loading...