34
The loading rolls infeed speed can be reduced by the regulating screw (see arrow
on following figure) under the hinged part of the loading chute. To change the
infeed speed, just turn the regulating screw accordingly.
Putting out of Operation
If you want to stop chipping:
- In case of loaded material wait for emptying of the loading chute.
- Wait for emptying of the discharge duct.
- Turn the tractor PTO shaft off.
Warning! The cardan shaft is equipped with a freewheel clutch. When
turned off, the rotor of the chipping device runs out – approximately 120
sec.
- Regardless of this running out, turn the switch key in the STOP position.
Emergency Situations
Put the chipper out of operation immediately in
following cases:
- If any person or animal approaches under 20 m while chipping, then stop
working immediately.
- If any breakage, damage or disengagement occurs, stop chipping immediately.
- If you heard any strange noise or vibrations or felt a strange smell while
chipping, then turn off the machine immediately and contact your dealer or
directly the manufacturer.
To Next Page
Loading...