27
Before coupling to a tractor, be aware of its max. PTO speed. If the
tractor does not reach the speed as required for the machine input shaft,
it is strictly forbidden to couple the machine to this tractor type.
Coupling of this machine to a tractor can be done as an attachment in the top and
bottom draw rods of the three-point linkage, category I or II. For the category II:
attachment from the external side by means of the connecting pins, 27 mm. For
the category I: attachment into a fork by means of the connecting pin, 22 mm.
According to an actual tractor tires size the connecting pins can be inserted into the
holes in two different heights.
The lower drawbar of the three-point
hitch can be coupled to a pin Ø 27 mm
from outside. The white arrow shows
a coupling point where the lower
drawbar is to be hinged. In both cases
the locking pin must be properly
locked.
Height adjustment by means of a hinge
pin
To Next Page
Loading...