30
- Press the green button for loading. CAUTION!! The loading rolls start turning
immediately.
- Having turned the chipping device on wait for speed stabilization. With that
you may soever increase or reduce the tractor PTO shaft speed.
- CAUTION!!! As soon as the PTO shaft starts turning, the hydraulically
powered elements can be set in motion as the hydraulic system of the
machine is already pressurized.
- CAUTION !!! As soon as the PTO shaft is ON then chips from previous
operation may be ejected from the discharge duct.
- Carry out functional checks of the safety frame for loading. Push the frame in
the in-feed position and the loading rolls start turning (loading). By next short
pushing the frame the rolls should stop turning immediately – EMERGENCY
STOP position.
Legend:
A - loading chute, B - safety frame, C - attendant's place, D - loading chute edge,
E - infeed direction, G – buttons for control of loading and reversing
- The safety frame must be always adjusted so that the
EMERGENCY STOP must be activated before the point D – loading
chute edge.
- Do not leave the machine unattended.
To Next Page
Loading...