Lastec 621ER - Pre-Operation Inspection Checklist

Initial Set-Up
Pre-Operation Equipment Inspection Checklist
Initial Set-Up Lastec//021819 3-13
3
3.11 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Articulator.
 With the tractor and Articulator parked on level ground, verify that the Articulator is properly mounted
to the tractor and secure.
 Verify that the PTO shaft is properly mounted, and the shield retaining chains are secure.
 Verify that your cutting application falls within the proper PTO shaft range.
 Check the oil level in the gearbox.
 Inspect area around and under the gearbox for any oil leakage.
 Check the deck drive belts and idler tension springs for proper installation, tension and condition.
 Check all deck belts and idler tension springs for proper installation, tension and condition.
 Clean the entire deck area (including the underside of all belt covers) of all grease, oil, fuel, and grass
debris. Be sure to replace all covers, guards and shields.
 Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condition.
 Set the mower deck height to the desired level.
 Verify proper function of all gauge wheels.
 Verify that all warning decals are in place, visible and legible.
 Verify that all covers and safety devices are properly installed and secure.
 Check that the discharge chute is clear of debris, properly mounted, and in good condition.
 Inspect entire Articulator for loose or entangled parts, debris, obstructions, or neglected tools.
 Perform all safety, set-up, and pre-operation procedures listed in your tractor manual.
 Complete the appropriate maintenance checklist (section 5).