Table 20: Programmer
ID Function Unit Command
77 Program used as a basis for further commands [–] RMP_IN_04
88 Current segment number [–] RMP_IN_01
90 Number of preset program sequences [–] RMP_IN_02
92 Current program loop [–] RMP_IN_03
94 Currently running program (0 = no program currently running) [–] RMP_IN_05
Table 21: Contact input / output
ID Function Unit Command
96 Contact input 1: 0 = open / 1 = closed [–] IN_DI_01
98 Contact input 2: 0 = open / 1 = closed [–] IN_DI_02
100 Contact input 3: 0 = open / 1 = closed [–] IN_DI_03
102 Contact output 1: 0 = open / 1 = closed [–] IN_DO_01
104 Contact output 2: 0 = open / 1 = closed [–] IN_DO_02
106 Contact output 3: 0 = open / 1 = closed [–] IN_DO_03
Table 22: SW version
ID Function Unit Command
108 Control system [–] VERSION_R
109 Protection system [–] VERSION_S
110 Remote control (Command)
(remote control unit must be present)
[–] VERSION_B
111 Cooling system
(only for devices with active cooling)
[–] VERSION_T
112 Analog interface module
(interface module must be present)
[–] VERSION_A
113 Flow controller
(flow controller must be present)
[–] VERSION_A_1
114 RS 232/485 interface module or Profibus / Profinet
(interface module must be present)
[–] VERSION_V
116 EtherCAT interface module
(interface module must be present)
[–] VERSION_Z
117 Contact interface module
(interface module must be present)
[–] VERSION_D
118 Solenoid valve for cooling water
(Solenoid valve must be present)
[–] VERSION_M_0
V6 Integral Process Thermostats and High-Temperature Thermostats 57 / 198
To Next Page
Loading...
Need help?
General
