LAUNCH TECH X-PROG3 - Gear Box Programming

To Next Page

To Previous Page

LAUNCH

X-PROG

c. Conrm the key type, if the you are using a smart key, touch

YES

d. If the key generation is done, touch

OK t

o conrm.

• 3.2.2 Gear Box Programming

You can use gear box programming function to restore the old gear box data

or write in new data after a new gear box is replaced.

• Connecting diagnostic system for gear box programming

www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu