LAUNCH
CReader Series English User’s Manual
22
function must be performed so that the immobilizer control system on the car
identifies and authorizes remote control keys to normally use the car.
When the ignition switch key, ignition switch, combined instrument panel, ECU,
BCM, or remote control battery is replaced, anti-theft key matching must be
performed.
5.3.10 Injector Coding (Only applies to CReader 9081)
Write injector actual code or rewrite code in the ECU to the injector code of the
corresponding cylinder so as to more accurately control or correct cylinder
injection quantity.
After the ECU or injector is replaced, injector code of each cylinder must be
confirmed or re-coded so that the cylinder can better identify injectors to
accurately control fuel injection.
5.3.11 Electronic Throttle Position Reset (Only applies to CReader 9081)
This function enables you to make initial settings to throttle actuators and returns
the “learned” values stored on ECU to the default state. Doing so can accurately
control the actions of regulating throttle (or idle engine) to adjust the amount of air
intake.
5.4 Review
This function is used to review or delete the recorded DTC, Data Streams and
Freeze Frame.
To Next Page
Loading...
